Features:
- Measurement scope: Handles converter current, main voltage and temperature signals.
- Hardware coding: Uses rating-dependent coding resistors for the installed converter size.
- Board pairing: Works with the applicable DCS800 power-interface hardware.
SDCS-PIN-51 3BSE004940R0001 is selected by the full ABB identity, converter rating and installed board arrangement.
The current-coding and voltage-divider networks make a connector-only visual match insufficient for replacement approval.
Service planning must preserve the documented measurement paths and the non-isolated main-voltage safety boundary.
Apter Power can assist with quotation and documentation support for the ABB SDCS-PIN-51 3BSE004940R0001 Measuring Card.
ABB SDCS-PIN-51 3BSE004940R0001 Measuring Card Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Current path: Measures converter current through the installed rating-specific coding arrangement.
- Voltage path: Uses resistor-divider paths for main-voltage measurement.
- Temperature path: Carries the applicable converter temperature measurement signals.
- Signal boundary: Main-voltage measurement is not galvanically isolated from the control board.
- Converter rating: Match the board to the installed DCS800 current rating.
- Coding network: Record the fitted current-coding resistors before removal.
- Companion board: Confirm the applicable power-interface board arrangement.
- Drawing check: Reconcile the board identity with the approved converter documentation.
- Isolation: Isolate and discharge the converter before accessing the measurement board.
- Visual record: Capture connector orientation, coding parts and companion hardware.
- Continuity review: Check the approved current and voltage measurement paths before power.
- Mismatch stop: Stop when the installed rating or board pairing cannot be established.
- DCS800 maintenance: Supports exact-board replacement in documented converter hardware.
- Workshop evaluation: Provides the identity and safety boundary for board-level assessment.
- Outage planning: Defines the checks needed before removal and recommissioning.
- Spare control: Keeps rating-dependent measuring boards tied to the correct asset.