Features:
- Hermetically sealed stainless steel case protects internal electronics from moisture, dust, and corrosive contaminants in harsh industrial environments.
- Flexible mounting via ¼-28 threaded hole allows users to select stud, adhesive, or magnetic base mounting based on application requirements.
- Hazardous area approvals (CSA, ATEX, IECEx) enable deployment in classified locations worldwide without region-specific variants.
The 200350-09-00-01 is built to survive in demanding industrial settings where standard accelerometers would fail. Its hermetically sealed stainless steel case prevents moisture ingress, protecting the internal piezoelectric sensing element and electronics from corrosion. This makes it suitable for outdoor installations, washdown areas, and environments with airborne contaminants. The top-mounted MIL-C-5015 connector provides a weather-resistant interface that maintains signal integrity even when exposed to rain, humidity, or temperature cycling.
With no integral mounting stud, the 200350-09-00-01 allows users to choose the most appropriate mounting method for their specific application. The ¼-28 threaded hole on the bottom accommodates a range of options: a stud for permanent installations on flat surfaces, adhesive for non-metallic or curved surfaces where drilling is impractical, or a magnetic base for temporary test setups.
The 200350-09-00-01 carries CSA, ATEX, and IECEx approvals, making it suitable for deployment in explosive environments such as refineries, chemical plants, and offshore platforms. Its 100 mV/g sensitivity provides a strong signal that interfaces directly with standard vibration monitors and analyzers without requiring additional amplification. The differential voltage output is proportional to acceleration along the sensitive axis, allowing straightforward interpretation of machine vibration levels.
The 200350-09-00-01 Bently Nevada Accelerometer may still be available for purchase and support from Apter Power beyond
End-Of-Life (EOL) by the manufacturer (OEM).
Bently Nevada 200350-09-00-01 Accelerometer Manuals,
Datasheets, Drivers, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not
included with this equipment unless listed in the above stock item description. All prices are
shown in USD.
Bently Nevada 200350-09-00-01 Accelerometer Specs
General
- Manufacturer GE / Bently Nevada
- Model 200350-09-00-01
- Condition New Original ready stock
- Product Family
200350-10-00-01,200350-11-00-01,200350-12-00-01
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not
included with this equipment unless listed in the above stock item description. All prices are
shown in USD.
- Rotating Machinery Monitoring: For example, monitoring the casing vibration of small and medium-sized motors, fans, pumps, blowers, and compressors.
- General Industrial Scenarios: Used to identify imbalance, misalignment, looseness, and early failures of rolling bearings.
- Harsh Environments: IP68 protection (waterproof and dustproof), suitable for humid or dusty industrial sites.
- Firmware-less: This sensor does not contain a microprocessor or programmable chip, therefore firmware updates are not required.
- Hardware Updates: To improve monitoring performance, this is typically achieved by replacing the sensor hardware (e.g., upgrading from a 200350 to the more accurate 200355 series).
- Excitation: The sensor requires a constant current source drive of 18V to 28V DC (2 to 20 mA).
- Bias Voltage: The normal operating voltage should be between 8V and 12V DC.
- Physical Installation: 09 in the model number indicates that this probe is a no-stud version; suitable mounting bolts or bases must be provided by the user.