Features:
- Compact mounting: short 0.8-inch non-armored 1/4-28 UNF case.
- Probe lead: 2.0 m total length with a miniature ClickLoc connector.
- Approval boundary: ordering option 00 specifies no agency approval.
Bently Nevada 330171-00-08-20-02-00 is the compact-case alternative within the 3300 5 mm proximity probe range.
Its 2.0 m lead becomes part of the matched 5 mm measurement chain used for shaft vibration, position, Keyphasor, or speed input.
Selection should prioritize available mounting depth, non-armored cable protection, total electrical length, and confirmation that no certified option is required.
Availability of Bently Nevada 330171-00-08-20-02-00 is subject to Apter Power inventory and sourcing confirmation.
Verified Apter-hosted resources for Bently Nevada 330171-00-08-20-02-00:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Bently Nevada 330171-00-08-20-02-00 3300 5 mm Probe Specs
General
- ManufacturerBently Nevada
- Model330171-00-08-20-02-00
- ConditionNew Original ready stock
- Product Family3300 5 mm Proximity Transducer System
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Mounting-space review
- Case length: 0.8 in supports the documented compact threaded arrangement.
- Thread: match the receiving hole to 1/4-28 UNF.
- Torque: use 5.1 Nm as the recommendation and remain below the 7.3 Nm maximum.
- Exit clearance: reserve space for the non-armored lead and 25.4 mm bend radius.
Non-armored lead handling
- Abrasion control: separate the 2.0 m lead from sharp edges and moving surfaces.
- Bend radius: keep every turn at or above 25.4 mm.
- Strain relief: support the lead so pull force does not reach the probe or ClickLoc connector.
- Loop match: include the 2.0 m probe length when selecting the remaining 5 mm system components.
Use of option 00
- No agency approval: option 00 carries no hazardous-area approval marking.
- Project screening: establish the area classification before accepting this configuration.
- Replacement control: do not substitute it for an approved BR or other certified option.
- Documentation: record the no-approval status with the installed probe ordering code.