Product overview:
- 6.5 m extension cable for the 3300 XL NSv proximity transducer system
- Flexible stainless-steel armor with an FEP outer jacket and connector protectors
- BR identifies the Brazil country-specific approval ordering option
The 330930-065-04-BR forms the electrical connection between a compatible NSv probe and Proximitor Sensor. A 6.5 m cable is normally paired with a 0.5 m probe to complete a 7.0 m system length.
Match the probe, extension cable and Proximitor Sensor as one complete transducer loop before installation.
Bently Nevada 330930-065-04-BR Manuals and Datasheets
Important Notice: Probes, Proximitor Sensors, monitors, barriers, mounting hardware and other accessories are not included unless listed in the stock item description.
Exact ordering-code interpretation:
- 330930 - 3300 NSv extension cable
- 065 - 6.5 m (21.3 ft) cable length
- 04 - stainless-steel armor with FEP jacket and connector protectors
- BR - Brazil country-specific approval ordering option
Approval check: the current Bently Nevada country-specific approval guide lists BR for the 330930 family. Confirm the certificate and nameplate requirements for the destination project.
Typical measurement applications:
- Completion of a 7.0 m NSv loop when used with a 0.5 m proximity probe
- Radial shaft vibration and radial position monitoring
- Axial or thrust position measurement
- Keyphasor phase-reference, tachometer and speed measurements
The protected armored cable is suited to routed installations where mechanical protection and connector sealing are required. Measurement performance still depends on the matched probe, Proximitor Sensor, monitor input and target material.
Installation and compatibility checks:
- Verify that probe length plus extension-cable length equals the Proximitor Sensor system length
- Use a 0.5 m NSv probe with this 6.5 m cable for a 7.0 m loop
- Seat the ClickLoc connectors correctly and fit the supplied connector protectors
- Route the flexible armor without excessive bending, crushing or tensile load
- Confirm the Brazilian approval documentation and associated wiring arrangement
Replacement check: match cable length, armor and jacket, connector protection, total system length and approval suffix before commissioning.
Environmental and approval guidance:
- Extension-cable operating and storage range: -52°C to +177°C
- Cable construction: 75 ohm FEP-insulated coaxial cable
- Option 04 armor: flexible AISI 302 stainless steel with an FEP outer jacket
- Connector protectors help limit liquid entry at the ClickLoc connections
- BR is the Brazil country-specific approval option for the 330930 family
Hazardous-area suitability depends on the delivered nameplate, certificate, entity parameters, approved wiring method and local jurisdiction. Verify the complete transducer loop before installation.