Features:
- High-pressure duty: Rated for probe pressure up to 1000 psig (6.89 MPa).
- Reverse-mount format: The 8 mm probe is configured for use with the dedicated Metrix 5499 mounting assembly.
- 7200-compatible identity: The exact ordering code defines the 3/8-24 UNF case, 0.5 m lead, and connector configuration.
The 0.2 in unthreaded length and 1.2 in case length identify the mechanical format used by this catalog code.
A Tefzel-insulated coaxial lead connects the probe to the matched extension-cable and driver chain.
The Model 5499 housing adds sleeve protection and controlled gap adjustment for reverse-mount service.
Apter Power supplies and supports the Metrix 10026-02-12-05-02 high-pressure proximity probe with exact-part review for installed 7200-compatible systems.
Metrix 10026-02-12-05-02 High-Pressure Proximity Probe Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Reverse mount only: This 10026 configuration installs through the dedicated reverse-mount arrangement rather than a standard forward-mount probe body.
- Pressure boundary: The high-pressure seal supports probe pressure up to 1000 psig (6.89 MPa) when the specified mounting hardware is used.
- Required housing: Metrix Model 5499 supplies the protective housing, adjustable sleeve, and locking arrangement for this probe style.
- Gap adjustment: The 5499 assembly provides separate coarse and vernier fine adjustment to help set the probe gap accurately.
- Probe lead: Suffix 05 identifies a 0.5 m lead that forms part of a matched 7200-compatible measurement chain.
- Signal cable: The 95 Ω coaxial lead uses Tefzel insulation for abrasion resistance and ProxMatch coding for system-length identification.
- Connector care: The gold-plated brass connector is tightened finger-tight plus one-eighth turn to maintain a reliable connection without over-torque.
- Cable routing: A minimum 25 mm bend radius helps protect the probe lead and reduce mechanical strain at the connector.
- Temperature capability: The probe and extension-cable system is specified for -40°C to +177°C service.
- Humidity boundary: The probe supports 100% condensing humidity when connectors are protected, but it is not intended for submersion.
- Material selection: A Ryton tip and 300 Series Stainless Steel case support demanding industrial installations.
- Reference target: Published system response is based on 4140 steel, so different target alloys should be reviewed during replacement engineering.
- High-pressure machinery: The sealed reverse-mount design supports non-contact shaft measurements where the probe enters a pressurized machine boundary.
- Radial vibration: The probe can serve in a matched 7200-compatible chain for monitoring shaft movement relative to the machine casing.
- Axial position: The same eddy-current measurement principle supports thrust-position observation when the installed monitor is configured for that task.
- Legacy system service: The exact code helps maintenance teams retain the required geometry and system length when supporting installed 7200-series equipment.