Features:
- Published family signal: the AM3100T2-Z2 family uses a 100 mV/g IEPE output for compatible constant-current channels.
- Mechanical interface: official family data specifies a top-exit design, 1/4-28 mounting and a two-pin MIL-style connector.
- Extended identity: the requested -00 suffix stays on the RFQ without an inferred option meaning.
Signal decision: confirm IEPE excitation and 100 mV/g channel scaling before connection.
Mounting decision: review the prepared surface, thread, cable route and connector together.
Identity decision: compare the full nameplate with the published AM3100T2-Z2 family record.
Apter Power supports Bently Nevada AM3100T2-Z2-00 Top-Exit IEPE Accelerometer sourcing with quotations, official documentation and configuration review.
Bently Nevada AM3100T2-Z2-00 IEPE Accelerometer Manuals,Datasheets,Link
Important Notice: Retain the complete AM3100T2-Z2-00 identity while using the validated AM3100T2-Z2 family characteristics for system review.
- Sensitivity: monitor scaling should be configured for 100 mV/g
- Constant current: the channel supplies 18 to 30 VDC at 2 to 10 mA
- Dynamic range: the published measurement range is 80 g
- Frequency response: the family covers 0.4 Hz to 14 kHz ±3 dB
- Mounting interface: the sensor uses a 1/4-28 UNF threaded connection
- Surface condition: a flat, clean and rigid base preserves vibration transfer
- Connector: the top-exit two-pin MIL-style interface should match the field cable
- Cable routing: strain relief and separation from interference support stable data
- No signal: confirm IEPE current, connector seating and cable continuity
- Incorrect level: review 100 mV/g scaling and mounting rigidity
- Excess noise: inspect cable routing, shield condition and connector contamination
- Loop acceptance: verify bias and vibration response against a known machine condition
- Motor monitoring: captures casing vibration across running-speed and higher-frequency content
- Pump and fan assets: supports permanent or route-based condition measurements
- Gearbox observation: provides broad-band acceleration for condition analysis
- Industrial retrofits: supplies a stainless IEPE sensor where the channel and mounting are compatible