Features:
- Product type is set to Additional display unit.
- The module's supported platforms are Multi-line 2 and AGC-4 Mk II.
- The communication is CAN bus.
DU-2/MKIII combines product type of Additional display unit, supported platforms of Multi-line 2 and AGC-4 Mk II, and communication of CAN bus in the Multi-line 2 / AGC-4 Mk II platform.
It provides a remote operator display and control interface over the controller CAN bus. This role connects the Multi-line Additional Display Unit to the surrounding Multi-line 2 / AGC-4 Mk II architecture.
Before commissioning, verify the controller platform and display count; observe the 200 m CAN limit and termination rules; and match the supply, cutout and gasket requirement.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for DEIF DU-2/MKIII:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Adds a remote operating position to generator and power-management controllers.
- Displays measurements, alarms and operating menus away from the main controller cabinet.
- Supports marine and land-based switchboards where multiple operator stations share one CAN network.
- The CAN network supports up to three connected display units.
- Equipment operation requires 200 m for maximum CAN length.
- The selected termination specification is end resistor required at bus ends.
- For this hardware, the value for front protection is IP40 standard; IP54 with gasket.
- The operating design assigns PC-ASA to housing material.
- The specification for operating temperature is -25 to +70 °C.
- For nominal supply, the selected value is 24 VDC.
- This configuration uses 8-36 VDC for supply range.
- The mounting arrangement is panel-mounted remote display.