Features:
- The board is identified for a 210 A SINAMICS S motor module.
- The associated module belongs to the 380–480 V, three-phase, 50/60 Hz class.
- The complete 1AA3 suffix distinguishes this spare board from adjacent interface-board configurations.
This order number covers the control interface assembly rather than the complete motor module.
Voltage, frequency and current values define the motor-module configuration to which the board belongs.
Identification therefore starts with the full order code before connector appearance is compared.
The Siemens 6SL3352-6TE32-1AA3 SINAMICS S Control Interface Board may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 6SL3352-6TE32-1AA3 Control Interface Board Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Separating the interface board from the power module
- Spare-part scope: The order number identifies a control interface board rather than a complete drive assembly.
- Installed position: The board belongs inside the specified SINAMICS S motor-module configuration.
- Current boundary: The 210 A figure describes the associated motor module, not a loose-board output rating.
- Voltage boundary: The 380–480 V range likewise belongs to the motor-module power class.
Checking the surrounding motor-module class
- Drive family: The target hardware is part of the SINAMICS S architecture.
- Power system: The associated motor module uses a three-phase AC supply.
- Frequency class: The module configuration is identified for 50/60 Hz operation.
- Current class: The intended motor module is the documented 210 A version.
Reading the complete spare-part number
- Base code: The 6SL3352 prefix alone does not identify this exact board configuration.
- Configuration block: The 6TE32 segment forms part of the documented motor-module association.
- Suffix check: The final 1AA3 characters must remain attached to the published order number.
- Visual limit: A similar connector layout does not replace the full-code comparison.
Applying whole-module values correctly
- Supply value: The 380–480 V figure belongs to the associated motor-module input class.
- Line value: The 50/60 Hz statement describes the module supply frequency.
- Current value: The 210 A value is tied to the complete motor-module configuration.
- Board value: None of those whole-module figures should be reassigned as an independent board output.