Features:
- Uses a rugged 19-inch aluminium chassis with a standard 6U height.
- Accepts up to fifteen single-width modules or a combination of wider cards.
- Distributes VME, tachometer, raw-signal, open-collector and power buses across the backplane.
The exact rack configuration is 204-040-100-012, identified as the standard ABE040 ordering entry.
It provides the mechanical and electrical foundation for VM600 rack power, processing, interface, relay and communications hardware.
The exact 012 ordering code is the standard rack entry and must not be replaced by the CSA configuration without a compliance review. Verify every front/rear card pair and the RPS6U arrangement against the rack build record.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Vibro-Meter 204-040-100-012:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Builds centralized machinery-protection systems for turbines, generators and large compressor trains.
- Houses condition-monitoring and communications card pairs in standard industrial cabinets.
- Provides shared power and signal buses for integrated VM600 plant monitoring architectures.
- The aluminium chassis uses a 19-inch, 6U mechanical format for permanent cabinet installation.
- Front slots support processing cards while rear positions accept associated input/output interfaces.
- Mounting brackets and card guides establish the alignment needed for reliable backplane engagement.
- The backplane carries the VME communication bus used by protection and controller cards.
- Dedicated Tacho, Raw and Open Collector buses distribute VM600 system signals.
- Backplane conductors also distribute regulated power from the installed RPS6U supplies.
- Cabinet airflow must remain clear around the 6U rack and its high-density card set.
- Panel structure should support the aluminium chassis without twisting the card guides.
- Leave access for rear I/O cards, input panels and earth connections during maintenance.