Features:
- 128 kB CPU configuration: This order code identifies the Ethernet-equipped PM554 processor.
- Onboard digital I/O: Eight inputs and six transistor outputs are integrated.
- AC500-eCo communication: Ethernet and the documented serial interface support controller integration.
The exact R0071 configuration adds onboard Ethernet to the PM554 digital-I/O processor while retaining 128 kB program memory and 24 V DC power.
It acquires local digital states, controls documented transistor loads, and communicates within the approved AC500-eCo architecture.
Check available program capacity, output current and wiring, Ethernet addressing, serial use, and the terminal-block package before purchase.
Availability is subject to Apter Power inventory and sourcing confirmation.
PM554-TP-ETH 1SAP120600R0071 Manuals, Datasheets, and Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
PM554-TP-ETH 1SAP120600R0071 AC500-eCo Processor Module Specifications
General
- ManufacturerABB
- ModelPM554-TP-ETH 1SAP120600R0071
- ConditionNew and factory sealed
- Product FamilyABB AC500
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
I/O terminal preparation
- Terminal types: Confirm the required 9- and 11-pole terminal blocks.
- Package scope: Verify whether the selected terminals are supplied or ordered separately.
- Channel map: Record the eight input and six output assignments.
- Wiring method: Match screw or spring terminals to the cabinet standard.
Network commissioning checks
- Address plan: Preserve the approved IP and subnet information.
- Protocol use: Confirm the Ethernet services enabled in the project.
- Switch port: Record the physical network connection and cable label.
- Backup: Save the controller project before network changes.
Initial controller checks
- Supply: Verify the 24 V DC source and polarity.
- Project size: Confirm the application fits the documented program memory.
- I/O test: Test each used channel in a controlled sequence.
- Diagnostics: Resolve power, run, error, or channel indications before service.