Features:
- Compact revision 3 CPU: ABB identifies 1SAP331000R0378 as the active PM5630-2ETH-XC 1SAP331000R0378 processor revision.
- Dual Ethernet and field communication: Two independent Ethernet ports work with serial COM1 and CAN on the selected terminal base.
- XC environmental design: The AC500-XC system data supports extended temperature and corrosive-gas conditions when installed as specified.
This CPU addresses compact modular projects where moderate application resources must be combined with multiple communication paths and harsh-environment capability.
The processor module requires a suitable TB56xx-2ETH(-XC) terminal base; base selection determines the available communication-module capacity.
Revision 3 projects should use a supported Automation Builder target, documented firmware, validated networking, and a commissioning plan that covers cold-start display behavior.
Availability is subject to Apter Power's current inventory and sourcing confirmation.
ABB PM5630-2ETH-XC 1SAP331000R0378 AC500-XC V3 Processor Module Manuals, Datasheets, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
ABB PM5630-2ETH-XC 1SAP331000R0378 AC500-XC V3 Processor Module Specs
General
- ManufacturerABB
- ModelPM5630-2ETH-XC 1SAP331000R0378
- ConditionNew Original ready stock
- Product FamilyABB AC500-XC V3
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Environmental installation checks
- Temperature: Confirm mounting orientation and the specified AC500-XC operating limits.
- Connectors: Protect unused connections in corrosive or salt-mist service.
- Display: Allow for slower LCD response below 0 °C.
- Enclosure: Verify humidity, ingress protection, vibration, and grounding requirements.
Project migration requirements
- Engineering tool: Use Automation Builder 2.6.0 or later for revision 3 deployment.
- Mixed revisions: Follow ABB firmware requirements when revision 2 and revision 3 CPUs share a project.
- Hardware target: Select the exact R0378 device in the validated project.
- Backup: Store the original project and a tested rollback package.
Application fit review
- Memory: Check compiled code, data, web content, and retained variables.
- Task load: Measure cycle time with communications and diagnostics active.
- Base capacity: Choose the terminal base by required communication-module slots.
- Growth margin: Reserve resources for approved future changes.