Features:
- Single-network F-Device role: The configuration targets one engineered PROFIsafe network.
- Distributed safety coordination: Controller and field-device behavior are validated as one safety function chain.
- Controlled network identity: Addresses, parameters and project signatures must remain traceable.
SM560-S-FD-1 1SAP286000R0001 fits AC500-S projects that need the CPU to participate as an F-Device on one PROFIsafe network.
Reliability depends on the approved network topology, unique safety addresses, compatible devices, timing and documented fault-response behavior.
Replacement work should preserve the project, device records, signatures, topology evidence and complete safety acceptance plan.
Availability is subject to Apter Power's current inventory and sourcing confirmation.
ABB SM560-S-FD-1 1SAP286000R0001 AC500-S Safety CPU Manuals, Datasheets, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
ABB SM560-S-FD-1 1SAP286000R0001 AC500-S Safety CPU Specs
General
- ManufacturerABB
- ModelSM560-S-FD-1 1SAP286000R0001
- ConditionNew Original ready stock
- Product FamilyABB AC500-S
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Topology: Document controller, master, switches and F-Devices.
- Boundary: Keep the approved PROFIsafe network scope unchanged.
- Timing: Validate update and watchdog behavior with final traffic.
- Failure test: Check network-loss and recovery response.
- Addressing: Assign and verify every safety address uniquely.
- Device record: Match exact hardware, firmware and configuration.
- Signature: Record the accepted project and safety signatures.
- Commissioning: Test each device before full-system validation.
- Diagnostics: Capture controller and device messages together.
- Physical network: Check power, cable, switch and connector conditions.
- Configuration: Compare addressing and parameters with the approved project.
- Recovery: Verify safe response before returning to service.