Features:
- 8 mm probe configuration: the housing is ordered around a 3300 XL 8 mm measurement chain
- Direct mounting stack: no standoff is combined with 3.0-inch probe penetration
- One-metre cable: the probe cable and fitting set must remain part of the exact assembly record
Bently Nevada 31000-16-10-00-030-02-02 is a 31000 machine-case housing configuration for a standard 3300 XL 8 mm proximity probe.
Its code fixes the probe family, 1.0-metre cable, no-standoff geometry, 3.0-inch penetration, conduit accessories, and mounting thread.
Selection must preserve the target and insertion drawing, complete transducer chain, port assignment, sealed fitting arrangement, original gap baseline, and monitored channel scale.
Apter Power supports document review, quotation, and procurement for the Bently Nevada 31000-16-10-00-030-02-02 31000 Proximity Probe Housing Assembly while current OEM ordering remains available.
Bently Nevada 31000-16-10-00-030-02-02 31000 Proximity Probe Housing Assembly Manuals,Datasheets,Link
Important Notice: No qualified exact-model English PDF is attached. Use the complete product model in every document request.
- Probe family: the exact configuration uses the documented 3300 XL 8 mm probe.
- One-metre lead: the probe cable length belongs to the system-length record.
- Extension match: verify connector condition and matching extension-cable identity.
- Sensor match: the Proximitor sensor and monitor scale must agree with the installed channel.
- No standoff: the housing mounts without an additional adapter in the mechanical stack.
- Three-inch penetration: the ordered reach must agree with the target surface.
- NPT interface: the housing uses a 3/4-14 NPT machine mounting thread.
- Adjustment proof: final gap is confirmed electrically and mechanically under the approved procedure.
- Two fittings: both specified conduit fittings belong to the exact configuration.
- One closure: the ordered plug seals the documented unused port.
- Cable path: route and restrain the one-metre probe cable without connector loading.
- Environmental seal: inspect thread engagement and housing closure before returning the machine.
- Radial shaft vibration: protect a documented 8 mm probe point through a machine casing.
- Bearing position monitoring: preserve target and gap geometry during controlled service.
- Compressor and turbine protection: retain the complete probe, cable, sensor, and monitor path.
- Accessible probe maintenance: use the external housing for inspection without losing the approved insertion record.