Bently Nevada 330101-02-70-10-11-05 configuration
The 330101-02-70-10-11-05 is a standard-mount 3300 XL 8 mm proximity probe for reliable vibration and position measurement on fluid-film bearing machinery.
- Probe family: 3300 XL 8 mm, 3/8-24 UNF thread, without armor
- Mechanical options: 0.2 in unthreaded length and 7.0 in overall case length
- Lead configuration: 1.0 m FluidLoc cable with protected ClickLoc connector
- Approval option: 05, CSA, ATEX and IECEx approvals
Bently Nevada 330101-02-70-10-11-05 Manuals and Datasheets
Important Notice: Extension cables, Proximitor Sensors, mounting hardware, calibration data and other accessories are not included unless listed in the stock item description.
330101-02-70-10-11-05 ordering code
- 330101: 3300 XL 8 mm probe, 3/8-24 UNF thread, without armor
- 02: 0.2 in unthreaded length
- 70: 7.0 in overall case length
- 10: 1.0 m (3.3 ft) total probe length
- 11: miniature coaxial ClickLoc connector with connector protector and FluidLoc cable
- 05: CSA, ATEX and IECEx approvals
Configuration check: Confirm mechanical clearance, cable routing, complete system length and delivered approval documents before installation.
Typical measurement applications
- Radial vibration and radial position measurement on fluid-film bearing machines
- Axial or thrust position measurement on suitable conductive targets
- Keyphasor phase-reference, tachometer and speed measurements
- Oil-exposed machinery locations where FluidLoc cable helps prevent liquid migration through the cable interior
The probe measures static position and dynamic vibration when used with the matching 3300 XL extension cable and Proximitor Sensor.
Probe setup and system matching
- Provide a 3/8-24 mounting interface with sufficient clearance for the 7.0 in case
- Maintain at least a 25.4 mm (1.0 in) cable bend radius and protect the ClickLoc connection from contamination
- Select the extension cable so the combined probe and extension length matches the selected 3300 XL Proximitor Sensor system length
- Use the nominal 1.27 mm (50 mil) gap with the specified AISI 4140 steel target unless the application is separately calibrated
- Check target size, shaft diameter, side clearance and probe-to-probe spacing before final installation
Environmental limits and approvals
- Standard probe operating and storage temperature: -52°C to +177°C (-62°F to +350°F)
- Probe construction: PPS tip, AISI 303 or 304 stainless-steel case and 75 Ω FluidLoc cable
- Minimum cable bend radius: 25.4 mm (1.0 in)
- Approval option 05: CSA, ATEX and IECEx approvals
Hazardous-area note: Suitability depends on the delivered nameplate, certificate, entity parameters, approved wiring method and local jurisdiction. Verify every requirement before installation.