Product overview:
- Non-contact eddy-current probe for static position and dynamic vibration measurement
- Standard-mount 3/8-24 UNF body without protective armor
- 3.9 in unthreaded length, 4.7 in case and 1.0 m standard ClickLoc cable
The 330101-39-47-10-02-05 probe is one component of a complete 3300 XL 8 mm system. Use the correct Bently Nevada extension cable and Proximitor Sensor so the combined electrical length matches the selected sensor system.
Approval option -05 identifies CSA, ATEX and IECEx approvals; confirm the delivered markings and certificates before installation.
Bently Nevada 330101-39-47-10-02-05 Manuals and Datasheets
Important Notice: Other accessories, manuals, cables, calibration data and software are not included unless listed in the stock item description.
Exact ordering-code interpretation:
- 330101 - 3300 XL 8 mm probe, 3/8-24 UNF, without armor
- 39 - 3.9 in unthreaded length
- 47 - 4.7 in overall case length
- 10 - 1.0 m total probe length
- 02 - ClickLoc connector and standard cable without connector protector
- 05 - CSA, ATEX and IECEx approvals
Configuration check: the 3.9 in unthreaded length is 0.8 in shorter than the 4.7 in case, matching the official ordering rule.
Typical measurement applications:
- Radial shaft vibration on fluid-film bearing machines
- Axial or thrust position measurement
- Keyphasor phase-reference and speed measurement when applied per Bently Nevada guidance
- Non-contact measurement of conductive shaft surfaces
The 3300 XL 8 mm system measures both static position and dynamic vibration. The standard 5 m system complies with applicable API 670 performance requirements; this 1.0 m probe must be matched with the correct extension cable and Proximitor Sensor for the intended system length.
Installation and compatibility checks:
- Confirm the 3/8-24 UNF mounting thread and 4.7 in case-length clearance
- Allow for the 3.9 in unthreaded section and observe the 25.4 mm minimum cable bend radius
- Use the correct extension cable and Proximitor Sensor to maintain total electrical length
- Confirm performance for target materials other than AISI 4140 steel
- Maintain suitable probe-tip spacing to limit cross-talk
Replacement check: match thread, unthreaded length, case length, cable type, system length and approval option before installation.
Environmental and approval guidance:
- Standard-cable operating and storage range: -52°C to +177°C
- Option 02 uses the standard FEP-insulated cable and ClickLoc connector without protector
- Agency approval option 05 identifies CSA, ATEX and IECEx approvals
- Hazardous-area suitability depends on the delivered nameplate, certificates, wiring method and local jurisdiction
Install the approved system in accordance with the applicable Bently Nevada installation drawing and the delivered certification documents.