Features:
- Four fast counters: Measures pulse trains up to 200 kHz.
- Flexible decoding: Supports direction, individual and two-phase inputs.
- Eight compare outputs: Converts count thresholds into fast NPN control actions.
AFP2441 is the FP2-HSCT NPN module used when ordinary scanned inputs are too slow for pulse or encoder signals.
Each counter stores a signed 32-bit value and can use ×1, ×2 or ×4 multiplication to match the sensing method.
Fast comparison outputs allow count-based actions to occur without waiting for a complete application-program cycle.
For AFP2441 sourcing, Apter Power can help confirm FP2 rack fit, NPN logic, encoder mode, input filter and comparison-output requirements. Panasonic AFP2441 is listed as FP2 High-Speed Counter Unit.
Panasonic AFP2441 FP2 High-Speed Counter Unit Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Channels: Four independent high-speed counter channels.
- Rate: Counts input pulses up to 200 kHz.
- Range: Uses signed 32-bit values from negative to positive limits.
- Decoding: Direction, individual and two-phase input modes are available.
- Input supply: Rated 24 VDC at approximately 7.5 mA.
- ON threshold: At least 19.2 V and 6 mA.
- OFF threshold: No more than 5 V and 1.5 mA.
- Filter options: None, 4, 8, 16 or 32 µs by input group.
- Output type: NPN transistor logic.
- Comparison points: Eight count-based outputs are available.
- Multiplication: Select ×1, ×2 or ×4 counting.
- Response: Minimum input pulse width is 2.5 µs.
- Encoder tracking: Measures shaft or conveyor position at high pulse rates.
- Cut-to-length machines: Triggers comparison outputs at programmed counts.
- Packaging lines: Counts fast product or index events between PLC scans.
- Legacy FP2 service: Restores a verified NPN high-speed counter position.