Features:
- MC510 combines an 8 MB FEPROM program area with 8 KB EEPROM.
- The card stores both the processor operating system and its CFC project.
- CPU550 and CPU551 modules use the documented MC510 execution.
The removable program memory keeps processor software separate from the CPU hardware.
Offline and online loading provide two paths for transferring the same target project.
Card identity, processor assignment and project revision must remain together.
The Siemens 6DD1610-0AH6 SIMATIC TDC MC510 Program Memory Module may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 6DD1610-0AH6 SIMATIC TDC MC510 Memory Module Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Separating executable storage from parameter retention
- FEPROM area: Eight megabytes hold the operating system and processor program.
- EEPROM area: Eight kilobytes retain the documented parameter data.
- Nonvolatile role: The saved project remains on the removable card without CPU power.
- Capacity check: The CFC project size must fit the MC510 execution.
Assigning the MC510 to the intended SIMATIC TDC CPU
- CPU550: The processor accepts MC510 as an additional program-memory component.
- CPU551: The later processor is also listed with the MC510 card.
- Slot interface: The card enters the program-memory submodule slot on the CPU.
- Station record: The processor and slot assignment identify which program belongs on the card.
Choosing an offline or installed-card programming route
- Offline method: A PCMCIA programming adapter writes the removed memory module.
- Online method: A serial engineering link loads the card while it remains in the CPU.
- Project target: Both methods must address the processor program assigned in CFC.
- Verification: Read-back and station checks confirm that the intended project was written.
Keeping program media and station configuration synchronized
- Card label: Record the complete 6DD1610-0AH6 identity before transfer.
- Project revision: Match the CFC source and operating-system level to the saved image.
- CPU destination: Confirm that the destination is the documented CPU550 or CPU551.
- Startup review: Verify processor state and station communication after loading.