Features:
- External transducers measure flow without cutting into the pipe.
- Transit-time difference determines liquid velocity and flow direction.
- Portable battery operation and an IP67 enclosure support field measurement.
The meter needs the actual pipe, liquid and transducer arrangement before it calculates flow.
Reflect and Direct modes create different acoustic paths through the pipe.
Configurable outputs pass measured results to recorders or control equipment.
The Siemens 7ME35101CA000AA0 SITRANS FUP1010 IP67 Flowmeter may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 7ME35101CA000AA0 SITRANS FUP1010 Flowmeter Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Matching transducer placement to the selected measurement mode
- Reflect mode: The signal crosses the pipe and returns from the opposite wall.
- Direct mode: Opposed sensors exchange the signal across one direct path.
- Spacing: The calculated sensor distance depends on pipe and liquid data.
- Signal check: A usable arrival pattern is confirmed before accepting flow.
Turning installation data into the flow calculation
- Material: Pipe composition contributes to the expected sound path.
- Wall thickness: The entered wall dimension changes the calculated travel distance.
- Outside diameter: Diameter defines the cross-section used for volume flow.
- Liquid: Sound-speed behavior and temperature affect signal validation.
Keeping measurement and battery charging within their limits
- Battery pack: The internal NiMH assembly powers portable operation.
- Operating input: The external adapter feeds the documented operating range.
- Charging input: The charging range is observed when replenishing the battery.
- Enclosure seal: Connector covers preserve the IP67 boundary during field use.
Sending measured values to external recording or control
- Current outputs: Two 4 to 20 mA paths can represent configured process values.
- Voltage outputs: Two 0 to 10 V paths provide the documented analog alternative.
- Frequency outputs: Pulse frequency follows the assigned measurement function.
- External load: Loop supply and connected resistance remain within the terminal limits.