Features:
- 6GT2801-3BA10 combines the RF380R reader electronics and antenna in one IP67 housing.
- The radio side works with RF300-specific and supported ISO transponder protocols.
- An 8-pin M12 connector carries selectable RS422 or RS232 communication to the host.
A five-color LED gives local operating information without adding a separate indicator module.
Read distance depends on the transponder even though the reader limit is specified at 200 mm.
Direct metal mounting is permitted with a documented minimum separation of 0 mm.
The Siemens 6GT2801-3BA10 SIMATIC RF380R GEN2 Reader may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 6GT2801-3BA10 SIMATIC RF380R GEN2 Reader Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Radio-Side Selection
- RF300 mode: The reader exchanges data with Siemens RF300 transponders through its integrated antenna.
- ISO families: ISO 15693, ISO 18000-3 and ISO 14443 protocols are included in the supported set.
- Frequency: Every supported tag path operates through the 13.56 MHz reader stage.
- Single-tag boundary: 6GT2801-3BA10 does not provide multitag operation.
Reader-to-Host Connection
- Port hardware: RS422 and RS232 signals share the reader's 8-pin M12 connector.
- Host destination: The serial point-to-point path connects the reader to a communication module or PC system.
- Short run: RS232 wiring is limited to a maximum of 30 m.
- Long run: RS422 extends the documented cable distance to 1,000 m.
Antenna Placement Rules
- Housing position: The antenna is integrated into the RF380R enclosure rather than connected externally.
- Metal clearance: Siemens specifies a recommended minimum metal separation of 0 mm.
- Fastening: Four M5 screws secure the reader, with a maximum tightening torque of 1.5 N·m.
- Range check: Final placement must account for the transponder-dependent reading distance.
Local Indication and Limits
- Status display: A five-color LED reports the reader's local operating state.
- Supply path: The electronics accept 20.4–28.8 V DC around a 24 V nominal supply.
- Enclosure: IP67 protection applies to the assembled reader housing.
- Temperature span: Reader operation is specified from -25 to +70 °C.