Features:
- Independent multi-axis control: Positions up to three axes independently.
- Open- or closed-loop operation: Uses closed-loop positioning or open-loop limit-switch control.
- On-module program storage: Holds traversing programs and performs position control on the module.
The Siemens 6FM1726-3BA00 WF726B positioning module keeps the positioning task on the module, helping relieve the main SIMATIC S5 CPU of complete position-control work.
Its WF 726 operating concept supports independent axis positioning through either closed-loop control or open-loop limit-switch control. The selected machine implementation must retain the intended feedback and control arrangement.
Traversing programs are stored directly on the positioning module, so a service request should match the complete 6FM1726-3BA00 module identity before configuration or program recovery is considered.
Apter Power supports document review, quotation, and procurement for the Siemens 6FM1726-3BA00 WF726B Positioning Module.
Siemens 6FM1726-3BA00 WF726B Positioning Module Manuals,Datasheets,Link
Important Notice: Review the complete model and installed configuration before using any documentation for service work.
- Select by the complete 6FM1726-3BA00 code, not by a shortened WF-series reference.
- Use the WF726B designation together with the complete model when comparing the removed unit.
- Stop selection when the module marking or connector arrangement does not match the installed assembly.
- arrangement before removing 6FM1726-3BA00 from the equipment.
- Return the module only to the documented control-system position for the removed assembly.
- Use qualified electronic-module handling and site-approved ESD controls during replacement work.
- kaRecord the connector arrangement before removing 6FM1726-3BA00 from the equipment.
- Return the module only to the documented control-system position for the removed assembly.
- Use qualified electronic-module handling and site-approved ESD controls during replacement work.
- Start the service check with the complete 6FM1726-3BA00 marking and WF726B designation.
- Compare the removed unit’s connector arrangement with the installed-system record before a sourcing decision.
- Pause the replacement review if the physical interface or installed position cannot be confirmed.
- 6FM1726-3BA00 is identified as a Siemens WF726B positioning module.
- Use it only where the removed assembly and installed equipment record identify the same complete model.
- For similar WF-series hardware, keep the request within the documented connector and system-position boundary.