Features:
- Four relay outputs: The onboard normally-open contacts switch approved AC or DC loads.
- Compact Ethernet CPU: Control and communication are combined in a small AC500-eCo V3 module.
- Single option slot: One supported option board can extend the basic configuration.
This basic AC500-eCo V3 CPU combines six digital inputs, four relay outputs, and Ethernet for compact control panels.
The relay version is intended for properly protected AC or DC loads and requires careful review of contact ratings and switching duty.
Confirm terminal blocks, load suppression, fusing, RTC needs, network settings, and the validated project before commissioning.
The ABB PM5012-R-ETH Basic AC500-eCo V3 Relay Processor Module is listed as Active / Available from OEM; quotations and sourcing support may be available through Apter Power.
ABB PM5012-R-ETH Basic AC500-eCo V3 Relay Processor Module Manuals, Datasheets, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
ABB PM5012-R-ETH Basic AC500-eCo V3 Relay Processor Module Specs
General
- ManufacturerABB
- ModelPM5012-R-ETH
- ConditionNew Original ready stock
- Product FamilyABB AC500-eCo V3
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Contact-load review
- Voltage: Confirm each AC or DC load remains within the relay rating.
- Current: Check steady-state and inrush current.
- Duty: Compare switching frequency with contact-life expectations.
- Grouping: Document supply groups and common conductors.
External circuit protection
- Fuse: Provide the required channel protection.
- Inductive loads: Apply approved suppression outside the module.
- Isolation: Follow the documented phase and grouping rules.
- Maintenance: Inspect contacts and loads after abnormal events.
Controller startup checks
- Supply: Verify 24 V DC polarity and stability.
- Project: Load the validated PM5012 target.
- Ethernet: Confirm the approved address and connected switch port.
- I/O test: Exercise every relay circuit under safe conditions.