Features:
- 4 MB processor: The PM591-ETH order configuration provides 4096 kB program memory.
- Single onboard Ethernet: ABB documents web server, SNTP, and IEC 60870-5-104 services.
- Dual serial and FBP: Two RS-232/485 interfaces and one FBP interface are included.
This R0271 version is the single-Ethernet PM591 processor with two configurable serial interfaces and an FBP connection.
It executes the AC500 application while providing the documented local display, Ethernet services, and serial communication paths.
Match the terminal base, firmware, Automation Builder project, IP plan, serial protocols, and memory-card use before replacement.
Availability is subject to Apter Power inventory and sourcing confirmation.
PM591-ETH 1SAP150100R0271 Manuals, Datasheets, and Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
PM591-ETH 1SAP150100R0271 AC500 Processor Module Specifications
General
- ManufacturerABB
- ModelPM591-ETH 1SAP150100R0271
- ConditionNew and factory sealed
- Product FamilyABB AC500
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Single-Ethernet preparation
- Addressing: Record IP, subnet, gateway, and switch-port details.
- Services: Confirm only the Ethernet services approved for the project.
- Remote access: Apply the site network and security policy.
- Recovery: Keep an offline project and network backup before changes.
COM1 and COM2 review
- Physical mode: Confirm RS-232 or RS-485 for each interface.
- Protocol: Record programming, Modbus, ASCII, or CS31 use as applicable.
- Termination: Verify polarity, shielding, and termination for RS-485 wiring.
- Port record: Retain baud rate, address, and cable details.
Existing-system matching
- Terminal base: Match the installed base and connector arrangement.
- Firmware: Record the current CPU and project versions.
- Memory card: Preserve program, data, and update procedures.
- Startup test: Validate network, serial, I/O, and application operation.