Features:
- 18.5 kW normal-use power with 38 A output
- R3 IP21 wall-mounted frame
- Documented 134 m³/h cooling-air requirement
ACS510-01-038A-4 occupies the 38 A point in ABB's R3 ACS510 range.
The drive can coordinate motor speed with plant references and interlocks, but reliable operation depends on a correctly engineered enclosure, cable system, supply, and control network.
Before procurement, complete the motor-duty check, thermal calculation, EMC routing plan, protective-device selection, braking review, communication design, maintenance access, and diagnostic baseline.
Availability is subject to Apter Power's current inventory and sourcing confirmation.
ABB ACS510-01-038A-4 ACS510 General Purpose Wall-Mounted Drive Manuals, Datasheets, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
ABB ACS510-01-038A-4 ACS510 General Purpose Wall-Mounted Drive Specs
General
- ManufacturerABB
- ModelACS510-01-038A-4
- ConditionNew Original ready stock
- Product FamilyABB ACS510 Drives
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
R3 heat-removal controls
- Losses: Use the documented heat dissipation in the enclosure calculation.
- Air volume: Provide the specified cooling airflow without recirculation or obstruction.
- Ambient: Apply temperature and switching-frequency derating when required.
- Maintenance: Keep fans and cooling paths accessible for inspection and cleaning.
Cable and grounding discipline
- Segregation: Separate supply, motor, braking, and low-level control circuits.
- Shielding: Terminate shields according to the required EMC installation method.
- PE: Verify protective-earth continuity and the approved conductor arrangement.
- Control cable: Use specified twisted and shielded pairs for sensitive analog and serial signals.
Repeatable fault investigation
- Capture: Record code, time, command source, current, speed, and process state.
- Compare: Check accepted parameters against recent changes before tuning.
- Inspect: Examine airflow, motor and cable insulation, terminals, and mechanical load.
- Verify: Run controlled tests only after the suspected cause and safety conditions are addressed.