- Ten solid-state outputs for pulse-cleaning valves
- Universal 95–265 VAC input with nonvolatile settings
- Continuous or external pressure-demand operation
DNC-T2010-R20 sequences ten pulse valves so a baghouse can clean its filter rows without requiring an external PLC timing program.
The controller supports continuous cleaning or demand-based operation initiated through an external differential-pressure device, while retaining its programmed settings in nonvolatile memory.
Before replacement, record the valve firing order, pulse duration, interval timing, cleaning mode and pressure-demand wiring so the original filtration strategy can be restored accurately.
Availability, condition, price, and shipping time for DNC-T2010-R20 are confirmed during quotation.
AMETEK DNC-T2010-R20 Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Record pulse-on, pulse-off and last-output settings
- Label each valve conductor in its existing cleaning order
- Confirm continuous or pressure-demand operating mode
- Check every AC solenoid coil against the output VA limit
- Inspect shared neutral, fuse and protective-earth wiring
- Correct shorted coils or damaged cables before energizing
- Pulse each output individually before automatic sequencing
- Verify pressure-switch demand and release behavior
- Observe full cleaning cycles and confirm every valve responds
- Ten-solenoid pulse cleaning for baghouse dust collectors using a 95–265 VAC, 50/60 Hz supply
- Continuous baghouse cleaning with programmable pulse-on time, pulse-off time and last output
- Pressure-demand baghouse cleaning controlled by an external high-pressure switch