- Single-axis Kinetix 350 drive for a compatible 480 V-class Logix motion system
- EtherNet/IP motion services support coordinated control within the documented controller architecture
- Safe Torque Off terminals connect to a separately validated machine-safety circuit
2097-V34PR5-LM provides one EtherNet/IP-controlled servo axis and must be paired with the correct controller, motor, feedback device, and cable hardware.
The 480 V-class installation must follow the official requirements for supply, protection, grounding, connector access, cable routing, and enclosure cooling.
Preserve project and firmware records, then confirm regeneration, network settings, motor configuration, and Safe Torque Off validation before commissioning or migration.
Availability, condition, price, and shipping time for 2097-V34PR5-LM are confirmed during quotation.
Allen-Bradley 2097-V34PR5-LM Kinetix 350 Servo Drive Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Integrate the drive into a compatible EtherNet/IP motion network with CIP Motion and CIP Sync
- Match controller firmware, drive firmware, electronic keying, and axis configuration before connection
- Record IP addressing and project ownership before removing an installed drive
- Use the documented 780 V DC shunt turn-on and 750 V DC turn-off thresholds in system review
- Evaluate motor and load inertia, speed, deceleration time, repeated duty, and vertical-load behavior
- Confirm shunt and enclosure thermal requirements with the official Kinetix sizing resources
- Rockwell Automation identifies 2198-C4015-ERS as the engineering replacement
- Migration requires controller, motor-feedback, cable, panel, protection, and safety review
- Preserve the original project, firmware, wiring, and machine acceptance records before conversion
- Single-axis indexing and coordinated motion in compatible 480 V-class machinery
- Logix-based servo axes using the documented EtherNet/IP motion services
- Machine sections requiring a Kinetix 350 axis with Safe Torque Off