- Single-axis EtherNet/IP motion drive for a compatible Logix controller
- Series 1 Kinetix 350 hardware with published firmware revision 2.004
- Motor-output connector enhancement retained compatibility with existing motor-power cables
Allen-Bradley
2097-V34PR6-LM operates as one Kinetix 350 motion axis within a Logix-controlled EtherNet/IP system.
Controller support, Studio 5000 version, drive firmware, electronic keying, and the saved axis configuration must be checked together when the drive is commissioned or replaced.
Confirm the Series 1 nameplate, motor-output connector, motor-feedback pair, cable set, 2097-F2 line filter, 2097-R6 passive shunt, grounding, ventilation, and Safe Torque Off validation before use.
Availability, condition, price, and shipping time for 2097-V34PR6-LM are confirmed during quotation.
Allen-Bradley 2097-V34PR6-LM Kinetix 350 EtherNet/IP Servo Drive Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- The drive is configured as one EtherNet/IP motion axis in a compatible Logix project
- Electronic keying and axis ownership must match the installed controller configuration
- The saved motor, feedback, tuning, limits, and safety parameters require commissioning verification
- Rockwell Automation publishes Kinetix 350 firmware revision 2.004 for Series 1 hardware
- Controller, Studio 5000, and drive firmware compatibility must be checked together
- Back up the Logix project and record the installed firmware before replacement
- A more robust motor-output connector was introduced for 2097-Vxxx-LM drives
- The updated connector remains compatible with existing motor-power cables
- Inspect the connector, terminal engagement, cable condition, and grounding before reuse
- Single-axis Logix motion over EtherNet/IP
- Machines using a supported 400/480 V motor-feedback combination
- Legacy Kinetix 350 axes undergoing controlled service or engineered Kinetix 5300 migration