- Frame 2 Kinetix 5500 platform for one higher-current servo axis
- Integrated Motion over EtherNet/IP links the drive with a supported Logix controller
- Hardwired Safe Torque Off connects to the validated machine safety circuit
Allen-Bradley 2198-H040-ERS operates as one axis within a complete Kinetix 5500 system using a supported controller, motor, feedback device, brake option, and approved cable.
Its documented operating points cover 230 V and 480 V three-phase installations, and the actual supply and axis duty must be established before sizing.
Confirm controller and drive firmware, motor-feedback pairing, cable set, branch protection, regeneration, grounding, shield bonding, enclosure airflow, and safety validation before commissioning.
Availability, condition, price, and shipping time for 2198-H040-ERS are confirmed during quotation.
Allen-Bradley 2198-H040-ERS Kinetix 5500 Servo Drive Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Drive and axis fault information is available through the Logix motion connection
- DSL feedback provides motor-temperature information for supported motor combinations
- Solid-state motor overload protection uses the documented drive thermal model
- Bond the drive and enclosure according to the Kinetix 5500 installation instructions
- Use the documented shield clamps and connector hardware for motor cabling
- Verify the grounding-screw configuration for the installed power-source arrangement
- Install the drive upright to maintain the specified airflow direction
- Provide 40 mm airflow clearance above and below the drive
- Use an enclosure with at least the documented 300 mm cabinet depth
- Higher-current single-axis motion integrated with a supported Logix controller
- 230 V three-phase installations using the documented 4.0 kW operating point
- 480 V three-phase installations using the documented 8.3 kW operating point