Features:
- Accessory role: standard mounting stud for the 177230 Seismic Transmitter.
- Thread conversion: male 1/4-28 UNF to male M10 x 1.0.
- Installation purpose: adapts the transmitter base to a compatible metric machine mounting.
Bently Nevada 135826-01 is a mechanical mounting accessory, not a seismic transmitter or signal component.
Its two male threads provide the documented interface between the 177230 transmitter and an M10 x 1.0 mounting point.
Correct use depends on matching both thread pitches, preparing the surface, and following the transmitter installation procedure.
Availability of Bently Nevada 135826-01 is subject to Apter Power inventory and sourcing confirmation.
Verified Apter-hosted resources for Bently Nevada 135826-01:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Bently Nevada 135826-01 177230 Transmitter Mounting Stud Specs
General
- ManufacturerBently Nevada
- Model135826-01
- ConditionNew Original ready stock
- Product Family177230 Seismic Transmitter Accessories
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Interface orientation
- Transmitter side: male 1/4-28 UNF thread for the documented 177230 interface.
- Machine side: male M10 x 1.0 thread for the receiving metric hole.
- Adapter form: male-to-male standard stud with no sensing function.
- Identification: retain part number 135826-01 with the installation record.
Installation preparation
- Surface condition: use a clean, flat contact area for the transmitter base.
- Thread inspection: remove debris and reject damaged or mismatched threads.
- Alignment: start both connections by hand and stop if engagement is not smooth.
- Procedure: apply the mounting method and torque specified for the 177230 arrangement.
Compatibility review
- Device match: confirm the installed sensor is the documented 177230 Seismic Transmitter.
- Base thread: verify the transmitter accepts the 1/4-28 UNF side of the stud.
- Machine thread: confirm an M10 x 1.0 receiving hole with adequate engagement.
- Scope: do not treat the stud as a replacement for the transmitter, cable, or signal loop.