Features:
- Complete external housing: the 21000 assembly protects a reverse-mount proximity probe at the machine case
- Defined probe reach: 7.6-inch penetration and no standoff establish the mechanical stack
- Ordered fitting package: plug, reducer, cable seal grip, and grommets belong to the exact configuration
Bently Nevada 21000-16-10-00-076-03-02 is an aluminum proximity probe housing configuration built around a 3300 XL 8 mm measurement point.
Its complete order code binds probe choice, cable length, standoff decision, penetration, conduit accessories, and mounting thread into one installation identity.
Selection must preserve the machine-case drawing, target geometry, complete fitting inventory, probe system compatibility, environmental sealing, and baseline measurement evidence.
Apter Power supports document review, quotation, and procurement for the Bently Nevada 21000-16-10-00-076-03-02 Aluminum Proximity Probe Housing Assembly while current OEM ordering remains available.
Bently Nevada 21000-16-10-00-076-03-02 Aluminum Proximity Probe Housing Assembly Manuals,Datasheets,Link
Important Notice: No qualified exact-model English PDF is attached. Use the complete product model in every document request.
- External mounting: the assembly provides a serviceable probe enclosure outside the machine case.
- Dome cover: the housing closure protects the internal probe and termination area.
- Sleeve and seals: the ordered assembly includes the mechanical and sealing elements defined for the housing.
- Reverse-mount probe: the 3300 XL 8 mm option must remain consistent with the transducer system.
- No standoff: code 00 removes an added standoff from the dimensional stack.
- Penetration: the 7.6-inch value must match the approved target location.
- Mounting thread: the machine interface is the documented 3/4-14 NPT connection.
- Gap control: final insertion is set by the machine drawing and accepted electrical gap.
- Housing plug: one 3/4-14 NPT plug is included in the ordered accessory set.
- Reducer: the 3/4-14 to 1/2-14 reducer changes the conduit connection where required.
- Cable seal grip: the specified grip manages the probe-cable exit from the housing.
- Grommet set: receiving should confirm all grommets needed for the ordered seal arrangement.
- Turbine case monitoring: provide an external service housing for a documented radial probe point.
- Compressor vibration systems: retain probe reach and cable sealing at the machine casing.
- Bearing position measurement: preserve the approved target, insertion, and electrical gap.
- Maintenance-access installations: protect the probe termination while allowing controlled inspection and replacement.