Features:
- Uses an armored 3/8-24 UNF body with a 3.0 in case and no unthreaded section.
- Carries an 8 mm eddy-current signal through a one-metre standard coaxial lead.
- Includes a protected ClickLoc connection and the documented hazardous-area approvals.
Bently Nevada 330102-00-30-10-01-05 is the field probe in a calibrated 3300 XL 8 mm measurement loop.
Mechanical gap changes alter the probe field, and the Proximitor converts that change into the monitor voltage scale.
Armor, connector protection and thread engagement keep the electrical path stable while the machine operates.
The Bently Nevada 330102-00-30-10-01-05 8 mm Proximity Probe is covered by current OEM ordering documentation.
Bently Nevada 330102-00-30-10-01-05 Armored 8 mm Proximity Probe with 3/8-24 UNF Thread Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Threaded Reach and Initial Gap
- Body thread: The 3/8-24 UNF case secures the probe in the bracket.
- Case reach: The 3.0 in body defines the available threaded mounting depth.
- Tip position: The code-00 front section places the thread directly behind the probe tip.
- Gap setting: The cold gap is set near 1.27 mm before the monitor is commissioned.
Gap-to-Voltage Conversion Path
- Excitation: The Proximitor excites the probe coil through the matched coaxial circuit.
- Target coupling: Shaft distance changes eddy-current loading at the probe face.
- Scale conversion: The Proximitor converts the loading change to 7.87 V/mm.
- Measurement content: The output carries both average shaft position and changing vibration.
Armor, Cable and Connector Roles
- Armor path: Stainless armor protects the lead without becoming the signal conductor.
- Coaxial path: The one-metre standard cable carries the probe field connection.
- ClickLoc joint: The miniature connector joins the probe to the extension cable.
- Protector role: The connector protector shields the joined coaxial interface from field handling.
Matched-Length Verification Steps
- Length total: Probe and extension lengths must equal a supported Proximitor system length.
- Sensor family: Only the corresponding 3300 XL 8 mm Proximitor provides the documented scale.
- Gap check: Static output is checked after the complete electrical path is connected.
- Monitor scale: Alarm and display settings are verified against the 200 mV/mil system response.