Features:
- Provides eight electrically isolated discrete-output channels for independent 24 VDC field circuits.
- Switches supported 24 VDC loads through the card's specified output-channel arrangement.
- Requires B5 mechanical keying to match the card with its intended terminal block.
The current ordering configuration is KJ3208X1-BK1, the DeltaV S-Series 8-Channel 24 VDC Isolated Discrete Output Card documented by Emerson for DeltaV S-Series Traditional I/O.
KJ3208X1-BK1 is used in Isolated 24 VDC actuation of eight field loads from an S-Series I/O station. Its system role and configuration limits must remain aligned with the official specification.
Before commissioning KJ3208X1-BK1, verify the installed assembly, project wiring, power, software and environmental conditions that apply to this exact part number.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Emerson KJ3208X1-BK1:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Isolated 24 VDC actuation of eight field loads from an S-Series I/O station.
- Hazardous-area output assemblies installed under the card's stated approval conditions.
- Replacement of a BK1 card while retaining B5 keying and verified channel wiring.
- Remove every field-power source before inserting or withdrawing the output card from its carrier.
- Keep each connected load within the electrical rating assigned to its individual output channel.
- Follow the fused terminal-block service procedure whenever that protected termination option is installed.
- Apply the II 3G Ex ec IIC Gc marking only to the approved installation.
- Follow the referenced S-Series Zone 2 instructions.
- Check the actual label for serial and approval details.
- Operates from -40 to +70°C when the surrounding enclosure meets the listed installation conditions.
- Accepts 5 to 95 percent relative humidity without condensation at the card location.
- Select an enclosure for ISA Class G3 contaminants and the stated shock and vibration ratings.