Features:
- Connects an M-series controller to a PROFIBUS DP fieldbus segment for cyclic device-data exchange.
- Belongs to the earlier Series 2 Plus generation of DeltaV PROFIBUS interface cards.
- Supports existing simplex installations and the specified redundant PROFIBUS service arrangement.
VE4022 is the simplex controller-side assembly for an I/O.Connect PROFIBUS route.
The modernization value comes from translating retained remote-I/O information into the DeltaV environment rather than replacing every field termination by default.
Success depends on the exact rack, module and firmware entries in Emerson's compatibility information.
The VE4022 Emerson DeltaV I/O.Connect Simplex Profibus DP Interface Assembly may be available for purchase and support from Apter Power.
Emerson VE4022 DeltaV I/O.Connect Simplex Profibus DP Interface Assembly Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Retains remote I/O only when rack, module, and firmware entries appear in the validated compatibility tables.
- Connects approved legacy hardware through the simplex PROFIBUS route without qualifying unsupported modules.
- Requires another migration architecture whenever the installed rack cannot map to an accepted combination.
- Translates retained remote-I/O channel information into corresponding DeltaV I/O data structures during configuration.
- Preserves verified rack positions and channel assignments so field points remain traceable after migration.
- Checks data direction, signal type, and channel status before imported points enter control service.
- Uses DeltaV v14.LTS as the currently validated software baseline for this I/O.Connect configuration.
- Records remote rack family, module revision, and firmware before building the migration database.
- Validates the simplex PROFIBUS segment and controller download in staging before plant cutover.
- DeltaV modernization of supported PROFIBUS DP remote-I/O installations
- Simplex I/O.Connect architectures that require one M-series interface card
- Brownfield migrations where imported I/O data must be reconciled with an installed rack map