Features:
- Connection hardware for AMS 6500, AMS 6500 ATG and AMS 6300 SIS.
- Serial, USB, SMB and BNC interfaces are included in the kit bill of material.
- Configuration software and licensing remain separate from the hardware kit.
A6910 groups the service cables and adapters needed for supported connection workflows.
The target controller or monitor determines which cable path is used during service.
A contents check helps distinguish a complete kit from a partial offered set.
Apter Power supports Emerson A6910 Configuration Kit sourcing with quotations, technical documents and kit-completeness guidance.
Emerson A6910 Configuration Kit Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- One Sub-D9-to-PS/2 configuration lead supports the documented serial path.
- USB connection hardware supports a modern service computer.
- Two SMB signal leads are included for supported measurement access.
- Two SMB-to-BNC adapters extend compatibility with suitable test equipment.
- The service computer uses the documented USB connection path.
- The RS-232 adapter supports legacy serial access where required.
- Connector selection depends on the target AMS controller or monitor.
- Driver, software and license requirements remain separate from the hardware kit.
- SMB leads route supported measurement signals during service.
- SMB-to-BNC adapters provide a test-equipment interface.
- Connection points should follow the applicable system service procedure.
- Lead condition and connector fit should be checked before measurement work.
- AMS 6500 and AMS 6500 ATG configuration access.
- AMS 6300 SIS service-connection preparation.
- Signal access for supported commissioning and diagnostic tasks.
- Replacement of incomplete or damaged maintenance connection kits.