Features:
- Provides one Ethernet communication link for supported Ovation system equipment.
- Pairs with the 1X00569H01 personality module for straight RJ45 network termination.
- Operates as the electronics module in the Ovation Ethernet Link Controller assembly.
The current ordering configuration is 5X00419G01, a single-link Ovation Ethernet Link Controller module for straight RJ45 termination.
It provides one Ethernet link for connecting supported Ovation I/O and control-system equipment.
Before commissioning, confirm 1X00569H01 termination, straight-through RJ45 cabling, network addressing and the Ovation configuration.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Emerson 5X00419G01:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Connects compatible Ovation equipment to a dedicated copper Ethernet segment.
- Supports network communication between an Ovation controller environment and attached system hardware.
- Provides a service replacement for installed single-link Ethernet Link Controller assemblies using the matched termination module.
- A single copper Ethernet link carries control-system network traffic through the matched RJ45 termination module.
- The 1X00569H01 personality module provides the documented straight-through Ethernet connector arrangement.
- IP addressing, switch-port settings and network segmentation must match the active Ovation design.
- The electronics module is paired with the 1X00569H01 personality module for its physical Ethernet connection.
- Connected network equipment must be approved for the Ovation system architecture and configured link parameters.
- Replacement should retain the exact G01 controller variant to avoid interface or project-database mismatches.
- The matched 1X00569H01 personality module provides the documented straight-through RJ45 connector arrangement.
- Ethernet addressing and switch-port settings must remain aligned with the approved Ovation network architecture.
- Cabinet grounding, cable separation, and link verification must follow the documented control-network installation practice.