Features:
- Handles up to 2K discrete inputs and outputs in any mix.
- Supports as many as 8K analog I/O points.
- Executes a Boolean function in approximately 0.4 microseconds.
The VME C.1 backplane interface connects
IC697CPU772 with Series 90-70 I/O and intelligent option modules in compatible CPU racks.
Software configuration replaces onboard DIP switches and jumpers; the processor compares the installed rack arrangement with the programmed configuration during startup and operation.
Password access, a battery-backed clock, and protected program memory support controlled operation when applications must retain logic and time data through a power interruption.
Apter Power can assist with quotation and availability enquiries for General Electric IC697CPU772 12 MHz Expandable Floating-Point CPU.
General Electric IC697CPU772 12 MHz Expandable Floating-Point CPU Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Series 90-70 hardware used with IC697CPU772
- CPU racks: IC697CHS750, IC697CHS782, IC697CHS783, IC697CHS790, and IC697CHS791 provide the supported backplane environment.
- Local I/O: Discrete and analog IC697 modules exchange data with the processor through the rack backplane.
- Genius I/O: IC660 and IC661 devices are reached through the appropriate Series 90-70 bus controller.
- Option modules: LAN interfaces, coprocessors, communication modules, and the I/O Link interface can extend the controller architecture.
- Processor position: The CPU occupies slot 1 of rack 0 and must not be placed in another slot.
Programming paths available to IC697CPU772
- Serial port: The front 15-pin connector provides an RS-422/RS-485-compatible SNP connection.
- Parallel programming: A programmer can use the upper connector on an IC697BEM713 Bus Transmitter Module.
- Ethernet option: IC697CMM741 or IC697CMM742 adds a TCP/IP programming path to the rack.
- Network setup: The Ethernet interface requires a valid IP address before the workstation can communicate with the PLC.
Operator controls and status indications on IC697CPU772
- Mode selection: The three-position switch selects STOP, RUN with outputs disabled, or RUN with outputs enabled.
- Remote operation: An attached programmer can control processor operation when the application permits remote changes.
- MODULE OK: The upper green LED remains on after successful power-up diagnostics.
- RUN indication: The center status indication follows program execution and the selected operating mode.
- Output state: The ENABLED indication shows whether application outputs are allowed to operate.
Control tasks suited to IC697CPU772
- Machine sequencing: Fast Boolean execution supports interlocks, motion-related sequencing, and coordinated equipment states.
- Process control: Floating-point calculations allow engineering values and calculated setpoints to be handled inside the control program.
- Material handling: Mixed discrete and analog capacity supports conveyors, routing equipment, and transfer systems.
- Distributed I/O: Genius bus support allows control points to be placed beyond the local CPU rack.