- Eight independently configured channels support current or voltage command signals
- Embedded HART communication supports compatible smart field-device loops
- Floating-point and integer output formats support different RX3i project conventions
IC695ALG728 is a General Electric PACSystems RX3i analog output module designed for multichannel current, voltage, and HART field control.
The module updates all eight channels from the RX3i backplane and uses an external 24 V DC user supply for the field-output circuitry.
Before installation or replacement, verify each channel mode, HART requirement, field-load resistance, user-power supply, terminal assembly, scaling, fault response, and controller project.
Availability, condition, price, and shipping time for IC695ALG728 are confirmed during quotation.
General Electric IC695ALG728 PACSystems RX3i 8-Channel Current/Voltage Analog Output Module with HART Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Any channel used for HART communication must be configured for the 4...20 mA output range
- HART scan time depends on the enabled channels in each group, retry settings, slot variables, and pass-through configuration
- Typical HART data updates are 0.7, 1.9, 3.0, or 4.0 seconds for one, two, three, or four enabled channels in a group
- All output settings are configured in software; no module jumpers are required
- Channels can be individually enabled or disabled and configured with scaling and offsets
- Output fault behavior can be configured for Hold Last State or an output default value
- The Module OK LED indicates whether the module is configured and operating normally
- The Field Status LED reports enabled-channel or field-power faults
- The Terminal Block LED reports whether the removable terminal block is properly installed
- Current-loop command of industrial process actuators in PACSystems RX3i systems
- Voltage-command interfaces for compatible industrial control equipment
- HART-enabled analog-output loops for compatible smart field devices