Features:
- Adds two switched 10/100 Ethernet ports to an RX7i rack.
- Supports SRTP, Ethernet Global Data, and TCP/IP services.
- Uses one IP address across both auto-negotiating RJ45 ports.
The internal switch allows line-style cabling while maintaining one logical interface.
Station Manager access provides low-level diagnostics through a dedicated RS-232 port.
Up to three Ethernet interface modules can be installed with one RX7i CPU.
General Electric IC698ETM001 PACSystems RX7i Ethernet Interface Module is available for quotation and official technical-file access.
General Electric IC698ETM001 PACSystems RX7i Ethernet Interface Module Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
IC698ETM001 Switched Port Behavior
- Port count: Two copper RJ45 connectors are provided.
- Switching: An internal switch joins both connectors.
- Addressing: The module uses one IP address.
- Negotiation: Speed and duplex negotiate automatically.
IC698ETM001 Industrial Ethernet Services
- SRTP: Controller programming and data services are supported.
- EGD: Cyclic producer and consumer exchanges are available.
- TCP/IP: Standard transport supports configured applications.
- Channels: Application channel limits are planned in configuration.
IC698ETM001 Station Manager Tools
- Service port: RS-232 provides local Station Manager access.
- LEDs: Front indicators expose module and link state.
- Logs: Network events support fault isolation.
- Statistics: Interface counters reveal errors and traffic.
IC698ETM001 Rack and Power Limits
- Module count: A CPU rack accepts up to three interfaces.
- Processor: The interface uses a 200 MHz processor.
- Typical 5 V: Backplane draw is about 1.2 A.
- Maximum 5 V: Budget as much as 1.5 A.