Features:
- Provides a rear-mount nine-slot RX7i chassis.
- Accepts seven single-width modules when no double-width modules are fitted.
- Uses J2 connectors for transfers up to 64 data bits per cycle.
Slot 0 is reserved for the power supply, while the CPU occupies the prescribed processor position.
Slot sensing removes the need for addressing jumpers on supported Series 90-70 rack-type I/O modules.
Optional fan assemblies support configurations containing processors, supplies, or VME modules that require forced cooling.
Apter Power provides quotation support and official GE documentation access for General Electric IC698CHS009 PACSystems RX7i Nine-Slot Rear-Mount Rack.
General Electric IC698CHS009 PACSystems RX7i Nine-Slot Rear-Mount Rack Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
IC698CHS009 Nine-Slot Arrangement
- Supply position: Slot 0 is 61.0 mm wide.
- CPU position: The processor uses its prescribed rack location.
- Standard spaces: Slots 1 through 8 are single-width positions.
- Final opening: Slot 9 accommodates a double-width module.
IC698CHS009 Module Combination Limits
- Single-width total: Seven modules fit when no double-width units are installed.
- Double-width total: Four double-width modules are the maximum.
- Mixed loading: Permitted widths may be combined within available spaces.
- Power check: The supply can reduce practical module capacity.
IC698CHS009 VME and Slot Sensing
- VME64: The rack supports the 64-bit VME standard.
- J2 connectors: High-speed backplane transfers use the J2 plane.
- Addressing: Supported rack I/O is sensed by slot position.
- Service port: An RJ-11 connector carries the I2C serial link.
IC698CHS009 Cabinet Integration
- Orientation: The chassis mounts from the rear to a wall or panel.
- Envelope: Rack dimensions are 283 x 320 x 190 mm.
- Projection: Series 90-70 modules add about 43 mm at the front.
- Fan choice: Use the IC697ACC62x fan assembly specified for the rack.