Features:
- Six RJ45 ports collect local 10/100 Mbit/s Industrial Ethernet connections.
- One single-mode BFOC interface extends the switched network over optical fiber.
- Redundant 24 V feeds and a signaling contact separate power availability from network status.
Copper traffic is switched locally or forwarded to the optical uplink according to the learned network path.
Management services expose configuration and diagnostic information without becoming part of the process-data route.
PROFINET monitoring and redundancy functions operate across the installed topology and documented port assignments.
The Siemens 6GK5206-1BC10-2AA3 SCALANCE X206-1LD Ethernet Switch may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 6GK5206-1BC10-2AA3 SCALANCE X206-1LD Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Following traffic across unlike media
- Copper access: Six RJ45 sockets connect local Ethernet devices at 10 or 100 Mbit/s.
- Optical extension: The BFOC port carries the switched traffic over single-mode fiber at 100 Mbit/s.
- Media boundary: The optical interface does not accept an RJ45 patch lead or multimode fiber.
- Forwarding path: Learned addresses determine whether frames stay on copper or cross the optical link.
Keeping both supply paths electrically correct
- Dual feed: Two 24 V DC inputs provide redundant power entry to the switch.
- Shared load: The redundant inputs support one device rather than two isolated network sections.
- Status output: The signaling contact reports the documented fault condition to external wiring.
- Power budget: Both supply paths must remain inside the specified voltage and current limits.
Using management without changing port roles
- Configuration routes: CLI and Web access provide direct management interfaces.
- Monitoring route: SNMP versions 1, 2c and 3 expose switch status to network management.
- PROFINET role: Class B services integrate the switch into a monitored automation network.
- Stored setup: An optional C-PLUG can retain device configuration outside the switch electronics.
Matching redundancy protocol to the installed topology
- MRP: Media Redundancy Protocol supervises a configured PROFINET ring.
- HRP: High Speed Redundancy applies its documented ring recovery behavior.
- PRP: Parallel Redundancy Protocol uses duplicate network paths where configured.
- Topology check: The selected protocol must match the actual port connections before commissioning.