Features:
- Sixteen 24 V DC inputs and sixteen protected outputs share one ET 200L-SC electronic block.
- A TB 32L terminal block organizes the field wiring and grouped load-supply paths.
- PROFIBUS DP communication and channel LEDs separate bus faults from individual input or output states.
Siemens 6ES7133-1BL11-0XB0 combines digital sensing and load switching in one ET 200L-SC block.
The terminal and load groups of 6ES7133-1BL11-0XB0 determine which field circuits share each supply path.
Bus diagnostics and channel indicators help isolate faults on 6ES7133-1BL11-0XB0.
The Siemens 6ES7133-1BL11-0XB0 SIMATIC ET 200L-SC 16DI/16DO Electronic Block may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 6ES7133-1BL11-0XB0 SIMATIC ET 200L-SC 16DI/16DO Electronic Block Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Digital Input Processing
- Channels: Sixteen inputs evaluate 24 V DC field states with the IEC 61131 Type 1 characteristic.
- Signal thresholds: The documented voltage ranges distinguish the logical zero and one states.
- Input delay: The standard response path adds the specified two-to-4.5-millisecond delay.
- Indication: A green LED follows the state of each digital input channel.
Load Switching and Supply
- Channels: Sixteen electronic outputs switch 24 V DC loads up to the per-channel current limit.
- Load groups: L+ is divided across the documented groups so supply and total-current checks follow the assigned terminals.
- Protection: Electronic short-circuit protection acts on the output stage.
- Mounting load: The allowed total output current changes with temperature and mounting orientation.
Station Communication
- Network path: The electronic block exchanges process data with the station through PROFIBUS DP.
- Rate: The supported bus rate reaches the documented 1.5 Mbit/s maximum.
- Control modes: SYNC and FREEZE functions are supported by the PROFIBUS interface.
- Fault indication: The red BF LED points troubleshooting toward bus wiring, address, configuration, or master communication.
Channel and Power Checks
- Input LEDs: Green indicators expose the physical state of the sixteen input channels.
- Output LEDs: Green indicators expose the commanded state of the sixteen output channels.
- Supply LED: A separate green indication confirms the monitored 24 V supply.
- Isolation: The input circuits are isolated from PROFIBUS DP, while channels within each field group are not isolated from one another.