Features:
- The seven-inch TFT surface combines 800×480 visualization with touch-based operator input.
- A single configurable RS422/RS485 port provides the controller communication channel.
- Alarm, recipe, trend and language functions are available within a transferred SMART Panel project.
The display, touch surface and enclosure seal form the operator-facing section, while power and serial wiring terminate at the rear.
Project data is prepared on the engineering computer and transferred only after the panel communication channel has been enabled.
The complete 3AX0 suffix identifies the SMART 700 order variant and must remain intact when matching the panel and its project file.
The Siemens 6AV6648-0AC11-3AX0 SIMATIC HMI SMART 700 Touch Panel may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
Siemens 6AV6648-0AC11-3AX0 SIMATIC HMI SMART 700 Touch Panel Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Front and rear arrangement
- Operator Surface: The display and resistive touch area share the front face of 6AV6648-0AC11-3AX0.
- Rear Connections: Power, RS422/RS485 communication and functional ground are reached from the back of the panel.
- Panel Seal: The mounting seal sits between the operator panel and the enclosure cutout.
- Clamp Set: Four supplied plastic clamps hold the SMART 700 against its mounting surface.
Serial communication path
- Controller Link: Configured process values enter and leave through the single RS422/RS485 connector.
- Port Mode: The rear DIP-switch arrangement sets the electrical behavior required by the serial connection.
- Shared Route: Controller data and operator-entered values use the same configured communication path.
- Interface Boundary: 6AV6648-0AC11-3AX0 does not add a separate Ethernet port to the SMART 700 hardware.
From engineering file to panel
- Project Creation: The SMART 700 project is prepared in the supported WinCC flexible engineering environment.
- PC Connection: The configuration computer is connected to the panel before transfer begins.
- Channel Enable: The applicable data channel must be enabled on 6AV6648-0AC11-3AX0 for the transfer step.
- Commissioning Flow: Mounting, bonding, power, PC connection, transfer and controller connection form the documented sequence.
Project-level interaction tools
- Alarm Handling: Configured alarm views present process messages and acknowledgment actions.
- Recipe Records: Recipe functions organize related values for operator selection and transfer.
- Trend Display: Trend views show configured process values over time on the panel screen.
- Language Change: A project can expose language switching for its configured operator texts.