Features:
- A 32-bit PCI interface connects the CP 5613 A3 to a compatible industrial PC.
- The 9-pin RS485 port supports PROFIBUS from 9.6 kbit/s to 12 Mbit/s and up to 124 DP slaves.
- DP-RAM, DP-Base, PG, and FDL functions connect the fieldbus schedule to the host application.
The card offloads PROFIBUS DP-master communication while the PC application reads and writes the configured process image through DP-RAM.
Conventional PCI compatibility is a hard selection boundary and cannot be inferred from a PC simply having an available expansion slot.
Network faults are diagnosed across software release, driver state, connector wiring, termination, addressing, and bus timing.
The Siemens 6GK1561-3AA02 CP 5613 A3 PCI PROFIBUS Communications Processor is supported with product documentation and selection assistance from Apter Power.
Siemens 6GK1561-3AA02 CP 5613 A3 PCI PROFIBUS Card Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Industrial PC Hardware Fit
- Bus width: The card uses a conventional 32-bit PCI connector rather than PCI Express.
- Voltage: The keyed interface supports the documented 3.3 V and 5 V PCI signaling environments.
- Clock: Host operation is supported at 33 or 66 MHz PCI clock rates.
- Slot planning: Mechanical clearance, interrupt resources, and motherboard support are checked before installation.
PROFIBUS Process-Data Control
- Master role: The CP schedules cyclic exchange with configured PROFIBUS DP slaves.
- Slave count: A project may include up to 124 DP slaves within the network and timing limits.
- DP versions: DPV0, DPV1, and DPV2 services cover cyclic data, acyclic access, and supported advanced functions.
- Bus timing: Baud rate, station addresses, cycle targets, and slave diagnostics are resolved in the configuration.
PC Application Data Paths
- DP-RAM: Dual-port memory presents exchanged field data to the host application.
- DP-Base: The included runtime provides configuration and program access to the communications processor.
- PG protocol: Programming-device communication supports the documented engineering access.
- FDL: Fieldbus Data Link services carry configured non-DP communication tasks.
RS485 Segment Requirements
- Connector: The PROFIBUS cable terminates at a 9-pin Sub-D RS485 socket.
- Rate: The selected network rate may range from 9.6 kbit/s to 12 Mbit/s.
- Termination: Only the physical ends of the powered PROFIBUS segment are terminated.
- Shielding: Connector shield continuity and equipotential bonding are verified along the segment.