Features:
- Eight megabytes of Flash EPROM provide removable non-volatile S7-400 load memory.
- The card uses the long mechanical format and a 5 V controller interface.
- Correct selection requires the card technology, capacity, voltage, and physical format to match together.
Siemens 6ES7952-1KP00-0AA0 stores S7-400 project data on removable Flash EPROM media.
The stored load-memory contents remain on the card without relying on normal controller operating power.
An existing card should be identified by its full order number and 8 MB long-format 5 V specification before replacement.
Product manuals, quotations, and model-selection support for Siemens 6ES7952-1KP00-0AA0 are available from Apter Power.
Siemens 6ES7952-1KP00-0AA0 8 MB Flash EPROM Memory Card Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Mechanical and Electrical Identity
- Long design: The card body uses the documented long S7-400 format.
- Five-volt interface: The card is identified for the 5 V memory-card slot.
- Removable media: The card can be removed from the CPU slot when the approved handling procedure is followed.
- Order check: The complete article number distinguishes this capacity from visually similar cards.
Non-Volatile Load Memory
- Retention method: Flash cells retain written data without a backup battery.
- Project storage: The card carries the load-memory image written by the supported engineering process.
- Write behavior: Project changes are programmed to Flash rather than edited as battery-backed RAM.
- Power loss: Removing normal controller power does not erase programmed Flash content.
Eight-Megabyte Selection Limit
- Nominal capacity: The card provides eight megabytes of Flash EPROM storage.
- Project fit: The compiled load-memory requirement must remain within the available capacity.
- Replacement match: A previous card with a different capacity is not identified as the same configuration automatically.
- Archive check: The retained project archive should be compared with the card image before commissioning.
S7-400 Compatibility Checks
- Controller family: The host CPU must belong to the documented SIMATIC S7-400 memory-card platform.
- Slot voltage: The memory-card interface must support the 5 V card type.
- Mechanical length: The controller enclosure must accept the long-format card.
- Project release: CPU firmware and engineering software must support the saved controller project.