Features:
- Conditions the output of a compatible eddy-current proximity measuring chain.
- Provides stable shaft-position or vibration information to the associated monitoring channel.
- Identifies the exact IQS900 configuration through order number 204-900-000-011.
The selected configuration is an IQS900 proximity signal conditioner for a matched Vibro-Meter transducer system.
It supplies the electrical interface between the probe measuring chain and machinery monitoring equipment.
Confirm probe family, cable system, calibrated sensitivity, supply and monitor range before replacement.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Vibro-Meter 204-900-000-011:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Interfaces non-contact proximity measurements with rotating-machinery protection and condition-monitoring channels.
- Supports shaft vibration and position measurements when paired with the specified probe and cable assembly.
- Provides an exact-order spare for maintaining installed IQS900 transducer chains.
- The conditioner must be matched to the probe family and total electrical cable length of the measurement chain.
- Monitor scaling should use the sensitivity defined for the complete calibrated transducer arrangement.
- Record supply polarity, output range and connector assignment before disconnecting the installed unit.
- The output represents the proximity measurement delivered to the connected machinery-monitoring channel.
- Trend and alarm behavior should be compared with the prior baseline after a conditioner is replaced.
- Commissioning checks should confirm gap voltage, dynamic response and correct channel identification.
- Use only the approval and installation information stated for the exact 204-900-000-011 configuration.
- Hazardous-area suitability depends on the complete measuring chain and the approved cabinet arrangement.
- Retain label details and certification records when ordering a replacement for a regulated installation.