Features:
- IRB 6600 identity: ABB assigns 3HAC17117-2 to this robot
- Defined maintenance scope: piston-rod, bearing, sleeve, and sealing work is documented
- Referenced tooling: ABB specifies drawing 3HAC020270-003 and tool set 3HAC021984-001
- Lubrication detail: bearing grease quantities are stated for final assembly
3HAC17117-2 identifies the balancing device addressed by ABB for IRB 6600 maintenance.
Its official instruction follows the service path from removal through bearing, sleeve, piston-rod, sealing, fastening, and lubrication work.
The drawing and tool references make this page useful for planning the complete maintenance scope, not merely identifying the spare.
Apter Power can review 3HAC17117-2 document identity, condition evidence, maintenance-scope requirements, quotation, and shipment planning.
ABB 3HAC17117-2 IRB 6600 Balancing Device Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Piston assembly: the instruction covers the piston rod and bearing ear
- Support components: support bearing and bearing sleeve are included
- Spring-housing shafts: spherical roller bearings are replaced through the documented sequence
- Sealing work: Nilos rings, O-rings, and sealing compound are part of reassembly
- Main drawing: use assembly drawing 3HAC020270-003
- Bearing tool: ABB specifies tool set 3HAC021984-001
- Removal equipment: separator and puller equipment is defined for the shaft work
- Lubrication equipment: a grease gun for cartridges is listed
- Spacer installation: the radial seal and O-ring are assembled with the spacer ring
- Support bearing: the manual defines puller use and correct orientation
- Fastening: specified screws, locking parts, and tightening torques are used
- Final lubrication: the bearing ear and pedestals receive documented grease quantities
- IRB 6600 maintenance: service the documented balancing device
- Balancing-device overhaul: coordinate mechanical parts, seals, tools, and lubrication
- Planned robot repair: prepare the complete ABB instruction and assembly drawing before work