- Frame C 1336 PLUS II construction for higher-power motor-control systems
- Frame C supports a programmable 2...6 kHz carrier frequency, with the published drive rating based on 4 kHz
- Machine-specific control depends on the selected interface, feedback, Human Interface, and communication hardware
Allen-Bradley 1336F-B040-AA-EN must be integrated with the complete line, motor, enclosure, cooling, control, and safety architecture.
The actual load profile determines whether the constant-torque or variable-torque operating point applies and how braking or regenerative energy must be handled.
Confirm panel space, lifting and service access, fan condition, capacitor service state, cable routing, grounding, protective devices, and parameter records before commissioning.
Availability, condition, price, and shipping time for 1336F-B040-AA-EN are confirmed during quotation.
Allen-Bradley 1336F-B040-AA-EN 1336 PLUS II Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Two SP-135787 fan assemblies are listed for the B040...B050 rating group
- Operation above the documented 40 °C IP20 ambient requires the applicable derating or cooling design
- Airflow paths and service clearances must remain unobstructed in the enclosure
- Six SP-135775 bus-capacitor assemblies are listed for the B040...B050 group
- DC-bus service requires the documented discharge time and voltage verification
- Fault history and stored parameters should be captured before power-section service
- SCANport supports compatible Human Interface and communication peripherals
- Remote I/O options are available for the applicable frame range
- Serial or network-adapter settings must match the installed controller project
- Apply to a correctly sized 380...480 V three-phase induction motor
- Choose the duty rating from the torque, speed, and overload profile
- Coordinate panel access, cooling, braking, grounding, and protection with the machine design