Features:
- NSv geometry: armored M10 x 1 probe case with zero unthreaded length.
- Integrated reach: 60 mm case and 7.0 m total probe length.
- Connection option: miniature ClickLoc interface with multiple approvals.
Bently Nevada 330910-00-06-70-02-05 combines the longer 7.0 m lead with an armored metric case for an exact NSv ordering configuration.
Its PPS sensing tip and FEP-insulated coaxial lead operate as the probe element of a matched 3300 XL NSv measurement chain.
Selection depends on the installed M10 x 1 mounting, NSv calibration, cable path, target material, and project approval requirement.
Availability of Bently Nevada 330910-00-06-70-02-05 is subject to Apter Power inventory and sourcing confirmation.
Verified Apter-hosted resources for Bently Nevada 330910-00-06-70-02-05:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Bently Nevada 330910-00-06-70-02-05 3300 XL NSv Proximity Probe Specs
General
- ManufacturerBently Nevada
- Model330910-00-06-70-02-05
- ConditionNew Original ready stock
- Product Family3300 XL NSv Proximity Transducer System
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Measurement-chain matching
- Sensor family: retain the 3300 XL NSv probe, extension, and Proximitor calibration family.
- Electrical length: account for the documented 7.0 m probe lead when reviewing the installed loop.
- Target material: compare the machine target with the material used for the required calibration.
- Connector: mate the miniature ClickLoc interface without substituting an incompatible transducer family.
Lead-routing controls
- Bend radius: keep the cable path at or above the 25.4 mm documented minimum.
- Armor support: secure the flexible stainless-steel armor without crushing or sharply bending the lead.
- Connector protection: keep the ClickLoc surfaces clean and free from installation strain.
- Temperature exposure: route the probe within its documented -52 to 177 °C range.
Project documentation review
- Ordering option: code 05 identifies the documented multiple-approval configuration.
- Certificate set: compare the supplied markings with the destination and hazardous-area requirements.
- Loop scope: verify that the associated NSv system components share the required approval basis.
- Acceptance record: retain the full ordering code and applicable certificate with the installed asset history.