Features:
- Closes an unused module position in an Orbit 60 Series chassis.
- Provides the specified blanking part for the spare slot left by a CMM01-to-CMM02 replacement.
- Maintains the mechanical front-panel arrangement without adding powered electronics.
The current ordering configuration is 60R/BLK01, the Orbit 60 module-slot blank cover listed in the system accessories section.
Its principal maintenance role is to occupy the second slot released when a two-slot 60R/CMM01 is exchanged for a one-slot 60R/CMM02.
Before fitting the cover, verify the new module is fully seated, identify the genuinely unused position and inspect the chassis opening for obstructions.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Bently Nevada 60R/BLK01:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Fills an intentionally unused Orbit 60 chassis slot during initial rack assembly or later expansion planning.
- Completes the front-panel layout after a two-slot Condition Monitoring Module is changed to the one-slot CMM02 design.
- Supports orderly spare-slot management without introducing an unconfigured electronic device into the system.
- Fit the cover only in a confirmed unused Orbit 60 module position after the neighboring hardware is fully seated and retained.
- Guide the blank squarely into the chassis opening so it closes the slot without placing pressure on an adjacent module faceplate.
- Update the rack drawing after installation so maintenance personnel can distinguish the covered position from an active module location.
- The accessory matches Orbit 60 module-slot geometry and should not be substituted with a cover from another monitoring-system family.
- A CMM01-to-CMM02 conversion creates the specific unused position for which this blank cover is identified.
- The passive cover has no electronic address, firmware or signal interface and is not entered as a configured chassis device.
- Apply the site isolation procedure before working at the chassis whenever cabinet access requires the system to be secured.
- Do not install an improvised plate that could obstruct airflow, retention hardware or access to neighboring modules.
- Return the rack to service only after the blank and all surrounding module hardware are mechanically secure.