Features:
- Provides thirty-two high-side 24 VDC discrete outputs at 100 mA per channel.
- Uses optical isolation from the system with a 1500 VDC factory test.
- Enables termination-fault detection only with supported mass-connection hardware.
The current ordering configuration is KC3020X1-BA2, the DeltaV 32-channel high-side Plus discrete output card.
It gives process units a compact output interface for relays, indicators, solenoids, and other compatible 24 VDC loads.
Before commissioning, verify the B4 key, 3.2 A field-power budget, load current, simplex or redundant design, and the exact termination solution.
Availability is subject to Apter Power inventory and sourcing confirmation.
Verified resources for Emerson KC3020X1-BA2:
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Switches dense groups of low-current 24 VDC relays, indicators, solenoids, and interface circuits.
- Serves packaged equipment, utilities, sequence control, and process-unit discrete output assignments.
- Supports redundant high-density output assemblies when paired with the specified redundant termination hardware.
- Reports card-integrity conditions through DeltaV hardware alerts for maintenance visibility.
- Makes card and channel health information available through the DeltaV Diagnostics Explorer.
- Adds termination-fault detection only when a supported mass-connection or Pepperl+Fuchs HiC arrangement is installed.
- Uses the documented B4 rotary key to prevent connection to an incompatible terminal block.
- Requires verification of both 12 VDC Local Bus demand and the 24 VDC field-power capacity before loading the card.
- Allows online replacement only where the approved safe-area procedure permits it; hazardous locations require the applicable installation procedure.
- Carries the II 3G Ex ec nC IIC Gc marking for the documented hazardous-area configuration.
- Uses a conformally coated design that meets ISA-S71.04-1985 Class G3 contaminant requirements.
- Must be installed under the conditions and terminal arrangements stated in the applicable Emerson approval instructions.