Features:
- One DeviceNet network interface for DeltaV S-series.
- Supports up to 61 slave devices.
- Selectable 125, 250, or 500 kbit/s network operation.
This listing identifies complete Emerson model
SE4016 as DeltaV S-series DeviceNet Interface Card.
Connecting DeviceNet slave devices to a DeltaV S-series control system. Polling up to 61 field devices on one engineered DeviceNet segment.
SE4016 provides one DeviceNet port for up to 61 slaves. Segment length decreases as the selected data rate increases.
Availability: Contact Apter Power to confirm quotation and sourcing status for the complete model.
- Connecting DeviceNet slave equipment to a DeltaV S-series control system through one network port.
- Polling as many as sixty-one configured devices on a correctly engineered DeviceNet segment.
- Replacing an SE4016 card while preserving node addresses, device definitions, and mapped process data.
- Provides one DeviceNet interface for communication with as many as sixty-one slave devices.
- Configure every node on the segment for the selected 125, 250, or 500 kbit/s data rate.
- Apply the maximum cable-length limit that corresponds to the engineered DeviceNet network speed.
- Assign a unique network address to every connected DeviceNet node before communication is enabled.
- Load or verify the required device definition in the DeltaV configuration for each slave.
- Map polled input and output data to the intended DeltaV control-module parameters.
- At 125 kbit/s, the documented DeviceNet segment length can extend to 500 m.
- At 250 kbit/s, the maximum documented network segment length is reduced to 250 m.
- At 500 kbit/s, the specified maximum segment length is 100 m for the network.